New Concept SunShade, Innovative SunBlind!

	Sunblind is for blocking strong sun light and direct glares. It allows the driver to adjust the Sunblind angle easily for partial blocking of direct sun light.
	Sunblind improves safety by allowing the driver to block the direct glare while seeing through the gaps between individual blinds.
	Sunblind reduces the heat rise in the vehicle and had elegant and luxurious appearance. It shields interiors from sun aging.
	Extremely easy to extend and to attach to the window top or to retract out of the way.
Sunblind can be installed easily at any doors of vehicles.

view, adjusted horizontally		view, when closed
		Sunblind works by simply hanging the small steel hook ("A") on the window top. Sunblind angle can be adjusted easily by turning the adjusting knob, located near to the hook ("A") . When you don't need Sunblind, like rainy day, just take the hook off from the window top and then, it will be retracted and fitted into the box, shown at below.
view, up/down movement

How to Install

Size (WxHxL): 20 x 31 x 460 m/m (0.79 x 1.22 x 18.2 inch)

1) Clean the surface of window glass and window rubber lining, which is between door lock and window. 2) Select the proper position for attaching Sunblind and take off the cover of double-side tapes and put Sunblind onto the rubber lining. 3) According to the vehicle, you may need Part-A to install Sunblind. Put it into window rubber lining and fasten it with screw. - see also 7) -. 4) We recommend to use Sunblind later than 24 hours after attached by tapes. If you want to use it immediately, see 7).		5) After installed and if necessary, cut the excessive parts of upper wings of Sunblind with scissor according to the door frame. 6) Move the window down about half by window switch and hang the hook onto the window top and close the window. Turn the adjusting knob to set Sunblind angle. 7) If the door frame materials are fabric or not suitable to use tape, please fix Sunblind to the door frame with screws as follows. Take the case (body) by hand and turn the case down with holding the dropping parts (upper part and blinds) by the other hand and look into the case, which has small holes for inserting screws.

Remarks: Model 201 202 Applicable to Passenger Car Van, Jeep, Truck & Bus No. of Blinds - 31 - pcs. - 36 - pcs. Extended Height 435 mm (17.1") 500 mm (19.7") Min. Order 2,500 sets (5,000 pcs) Container (20 ft.) 17,500 sets (35,000 pcs.) per container Carton Packing (100 pcs.) 520 x 380 x 415 mm (25 kgs) 20.5 x 15.0 x 16.4 inch (55 lbs.) Please contact SAM DUK for further information and distributorship.